Toa-electronics C-IF500 Bedienungsanleitung PDF herunterladen (Seite 4)

1. Power indicator [POWER]

Lights when the power is supplied.

2. Transfer rate setting switch [MODE]

Sets the transfer rate of the data to be transmitted

via the unit.

3. Data transmission indicator [TX]

Lights when data is transmitted from the Slave

terminal.

4. Data reception indicator [RX]

Lights when data is received from the Slave

terminal.

5. AC adapter input terminal *

Connect the AC adapter to this terminal.

6. 12 V DC power input terminal *

Please connect with the power supply other than

the AC adapter by the cable that attached the

supplied clamp filter.

(Please attach a clamp filter to the nearest

possible position of this controller.)

7. Ground Terminal [GND]

Please be sure to ground.

8. Master connection terminal [MASTER]

Connects to the C-RM500 Remote Controller to

split the control data transmitted from the C-

RM500.

Terminating resistance switch [TERMINATION]

Set this switch to ON when connecting the C-

RM500. However, there is a case that the switch

is used in the OFF position depending on the

connection method.

Refer to p. 6 for details.

10. RS-232C terminal [SLAVE/RS-232C]

Converts the data received at the Master

Connection Terminal into the RS-232C signal

level and sends out the converted signal. The

RS-232C Terminal also converts an input signal

to the RS-232C terminal into the RS-485 control

signal, and outputs the converted signal from the

Master Connection Terminal.

11. Slave connection terminal [SLAVE/A – D]

Splits an input signal to the Master Connection

Terminal into 4 and sends out the split signals.

Caution

Up to 31 C-CC501, C-CC504, C-CC551, or C-

CC554 Combination Camera can be connected to

each Slave Terminal A-D.

4. NOMENCLATURE AND FUNCTIONS

[Front]

INTERFACE UNIT C-IF500

MODE

1234

TX RX POWER

12 3 4

[Rear]

GND

MASTER SLAVEDC IN 12V DC IN

12V

IN OUT RS-232C

GND GND

GND

OFF

TERMINATION

5 6 7 8 9 10

Transfer Rate 1 2 3 4

38400 bps ON ON ON ON

19200 bps OFF ON ON ON

9600 bps ON OFF ON ON

4800 bps OFF OFF ON ON

2turn

power supply

12V

IN GND

clamp filter

* Connect the DC power supply of 12 V/over 100 mA, which suited CE standard to either input terminal.

1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare

Toa-electronics C-IF500 Bedienungsanleitung Seite 4

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Toa-electronics C-IF500